First, the answer

Published third-party data puts faucet & sink in the 60–400 dollar range nationally — This is the narrowest band on the list, and it widens mainly when a discontinued mixer forces replacement instead of a cartridge swap. Every contractor prices independently, so treat that as a sanity check on a quote rather than a quote itself. The work itself is described under faucet & sink repair, and the number that ends up on the invoice comes from licensed plumbers in Illinois, not from this page. Local pages start with Arlington Heights.

What the data shows — reported ranges for faucet & sink in Illinois

Reported cost ranges, 2026. Ranges are published third-party figures, not quotes.
JobReported rangeWhat pushes it higher
Bathroom sink faucet$60–$200Corroded supply nuts, a cramped vanity and mixers with no stocked cartridge.
Kitchen sink faucet$100–$250Pull-out hoses, filtered-water branches and a deep cabinet limiting tool access.
Outdoor hose faucet$100–$300Frost-proof sillcocks, soldered connections and pipework inside the wall cavity.
Shower faucet$75–$200Tiled access, a seized cartridge and a valve body needing a rebuild kit.
Cartridge replacement part$10–$100Discontinued or brand-specific cartridges ordered in rather than carried on the van.
Faucet replaced rather than repaired$170–$360Three-hole to single-hole changes, new supply lines and a fitted deck plate.

Not a quote. These are third-party reported ranges, sourced from Angi, "How Much Does It Cost to Fix a Leaky Faucet? [2026 Data]", angi.com/articles/plumber-cost-to-fix-leaky-faucet.htm, fetched 2026-08-11. Only a licensed contractor who has seen the job can price it.

Where the money goes — the 5 factors that change the number

Pricing is set independently by each contractor, so this page lists what moves the number rather than a figure.

  1. 01

    Repair of the existing valve versus full fixture replacement

  2. 02

    Whether replacement parts are still available for the brand and model

  3. 03

    Corroded or seized shut-off valves that must be replaced first

  4. 04

    Number of holes in the deck and whether the new fixture matches

  5. 05

    Access under the cabinet

How it shows up — is faucet and sink repair actually the fix?

Paying for the wrong job is the most expensive mistake here. These are the signs that point to faucet & sink rather than something else.

  • A faucet drips when fully closed
  • Low flow at one fixture only
  • A leak underneath the sink cabinet
  • The handle is stiff, loose or spinning
  • Corrosion or staining around the base of the faucet

What the work involves — so a quote can be read line by line

  1. The valve type is identified — cartridge, ball, ceramic disc or compression
  2. Water is isolated at the stops and the fixture disassembled
  3. Cartridge, seats, springs or O-rings are replaced, or the faucet is replaced
  4. Supply lines, stops and the P-trap assembly are inspected
  5. Flow and shut-off are tested at full pressure

Faucet & Sink cost by city in Illinois

Labor rates, permit fees and travel distance all differ across Illinois, which is why the same job is not the same number in every market.

Illinois markets with a dedicated faucet & sink page
CityCountyPermit authority
Faucet & Sink in Chicago Cook CountyChicago Department of Buildings
Faucet & Sink in Aurora Kane CountyAurora Building & Permits
Faucet & Sink in Springfield Sangamon CountySet locally
Faucet & Sink in Decatur Macon CountySet locally
Faucet & Sink in Orland Park Cook CountySet locally
Faucet & Sink in Tinley Park Cook CountySet locally

Before anyone touches a pipe

Verify the license. It takes two minutes.

  • Who licenses the work: Illinois Department of Public Health (IDPH) together with the local jurisdiction.
  • Who pulls the permit: the licensed contractor, never the homeowner.
  • What to ask for: the license number, the registered name behind it, and an insurance certificate issued to the property address.
Check a license numberIDPH Illinois licensing in full
Chrome faucet with running water
Independent licensed professionals

How to avoid overpaying for faucet & sink

  • Get the scope in writing before the number: what is being replaced, what is being repaired, what is being left alone.
  • Ask whether the price is flat-rate or time-and-materials, and what the diagnostic charge covers.
  • Ask whether the permit and inspection fee is inside or outside the figure.
  • Ask what happens if the job opens up and turns out to be larger — get the change-order rule up front.
  • Confirm the warranty term on parts and on labor separately.
  • Verify the license number on the IDPH register before any work starts.

Answers first

Asked and answered — faucet & sink cost in Illinois

Is a dripping faucet actually worth fixing?

Yes — a steady drip wastes a meaningful volume over a year, and the same worn seat that drips is usually also scoring the valve body. Catching it early keeps it a cartridge replacement instead of a fixture replacement.

Why is water pressure low at only one faucet?

A single fixture usually means a clogged aerator or a partially closed or failing angle stop, not a house-wide pressure problem. Aerator cleaning is the first thing to rule out.

Can I supply my own faucet?

Many contractors will install an owner-supplied fixture but will not warrant the fixture itself. Ask how it affects the labor warranty before buying.

How does the callback request work?

The 30-second form asks for a name, ZIP and the number to reach you on. The request routes to an independent licensed professional covering that area, and they call you back. Consent for marketing contact is optional — the request goes through with or without it.

Which areas does PlumberIllinois cover?

All of Illinois: the site lists every covered city with real ZIP codes, the county permit authority and nearby coverage, so requests route to a professional already working that area.

Is PlumberIllinois a plumbing company?

No. Independent licensed professionals perform and contract the work directly with you. PlumberIllinois routes the request and links every page to the official Illinois license register.

Does PlumberIllinois charge homeowners anything?

No. PlumberIllinois may be compensated by a partner when a homeowner connects with a professional through the site. That never changes what the contractor charges for the job.

Does calling create any obligation to hire?

None. A call or a callback request is a conversation, not a contract. Scope, timing and price are only agreed if you decide to proceed with the professional handling Illinois.

Get connected

Faucet & Sink in Illinois

Say what is wrong and where in Illinois. An independent licensed professional calls you back; terms are agreed directly and the license can be checked before anything starts.

  • Requests handled around the clock
  • An independent licensed pro calls you back
  • No obligation to hire

Prefer a call back?

Thirty seconds now — an independent licensed plumber calls you back.

Records for this request are provided electronically; a paper copy is free on request and the agreement can be withdrawn at any time — electronic records notice.

Submitting without the box still sends the request. PlumberIllinois is a referral service, not a plumbing contractor. Stop contact any time